Hioki IM3570 User Manual (English)

Other manuals for Hioki IM3570

Questions and Answers:

G
gutierrezrichardAug 1, 2025
Why do the measurement values differ on my Hioki IM3570 Measuring Instruments when measuring a known test sample?
- M
  Michele KingAug 1, 2025
  The measurement values may differ because the measurement conditions of the known test sample and the instrument do not match. Ensure that the measurement conditions match. Also, perform open and short compensation again. Turn load compensation off. Ensure there is an appropriate trigger delay and trigger synchronization output wait time. If you are measuring a test sample other than a capacitor, turn the DC bias function OFF.
J
julietaylorAug 4, 2025
What to do if keys do not work on Hioki Measuring Instruments?
- A
  Adrian LawsonAug 5, 2025
  First, check if the keys are locked and disable the key lock. Second, check if the unit is being remotely operated from an external device using the communication cable and switch to the local state.
L
Louis TapiaAug 9, 2025
Why are key response and screen drawing slow on my Hioki Measuring Instruments?
- D
  davidmartinAug 9, 2025
  When the measurement value automatic output function is enabled, key response and screen drawing may become slow in order to give priority to measurement and measurement value output.
W
webbtaylorAug 13, 2025
Why is an error beep sound emitted continuously from my Hioki IM3570 Measuring Instruments?
- R
  Ronald TaylorAug 13, 2025
  When the measurement value automatic output function is enabled, a send error occurs on the measuring instrument side if the receive operation is not performed on the PC side, and a send error sound is emitted continuously when, for example, there is an internal trigger. Perform the receive operation on the PC side and then perform measurement on the measuring instrument side, or disable the measurement value automatic output function.
C
Carol MurphyAug 18, 2025
Why is a contact error generated on Hioki Measuring Instruments even though the connections are correct?
- J
  Janet GutierrezAug 18, 2025
  If you are measuring an element other than a capacitor using the DC bias function, turn the DC bias function OFF.
T
Teresa WashingtonAug 22, 2025
What to do if a key other than the pressed one is pressed on Hioki Measuring Instruments?
- A
  Ashley NicholsAug 22, 2025
  Perform panel compensation.
M
Melissa WilsonAug 27, 2025
Why does the LCD appear blurred on Hioki IM3570 Measuring Instruments?
- P
  petercalhounAug 27, 2025
  If you are pressing the LCD screen too hard, press it gently. Slight blurring may occur, but this is normal.