Hirschmann GREYHOUND GRS1020 - Scope of Delivery; Accessories

54
Installation GRS1020/1120/1030/1130
Release 03 01/2017
 Scope of delivery
 Accessories
Note:
Note that products recommended as accessories may have
characteristics that do not fully correspond to those of the respective
product. This may limit their possible usage in the overall system.
Number Article
1× Device
1 × 2-pin terminal block for signal contact
1 × 3-pin terminal block for the supply voltage
(only for device variants featuring supply voltage with the characteristic value M9)
2 × 3-pin terminal block for the supply voltage
(only for device variants featuring supply voltage with the characteristic value MM)
1 × 2-pin terminal block for the supply voltage
(only for device variants featuring supply voltage with the characteristic value C9)
2 × 2-pin terminal block for the supply voltage
(only for device variants featuring supply voltage with the characteristic value CC)
2 × Bracket
1 × General safety instructions
Gigabit Ethernet SFP transceiver Order number
M-SFP-TX/RJ45 943 977-001
M-SFP-TX/RJ45 EEC 942 161-001
The following operating conditions apply to twisted pair transceivers:
 Usable with:
- HiOS as of software version 03.0.00
- Classic Switch software, as of software version 04.1.00.
- HiSecOS as of software version 01.2.00
Do not use with the following devices:
- SPIDER II- MSP/MSM
- EES
 Longer RSTP switching times and link loss detection times compared to twisted pair ports
provided by the device directly.
 Not applicable for combo and Fast Ethernet ports.
 Only support of the autonegotiation mode including autocrossing.
M-SFP-SX/LC 943 014-001
M-SFP-SX/LC EEC 943 896-001
M-SFP-MX/LC EEC 942 108-001
M-SFP-LX/LC 943 015-001
M-SFP-LX/LC EEC 943 897-001
M-SFP-LX+/LC 942 023-001
M-SFP-LX+/ LC EEC 942 024-001
M-SFP-LH/LC 943 042-001
M-SFP-LH/LC EEC 943 898-001
M-SFP-LH+/LC 943 049-001
M-SFP-LH+/LC EEC 942 119-001
SFP-GIG-LX/LC
a
942 196-001