Sensor Calibration
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 12
24 183 69 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
• With boom fully retracted turn the center screw of the length pot unit counter clockwise to a soft
stop.
• During adjustment an additional button "OK" appears. Check value and set actual length as fully retracted
length by pressing OK.
▼ Adjustment, min length:
leave the service menu
carry out min. boom length setting
skip calibration step / go to next menu
Afterward next calibration screen appears:
To Next Page
Loading...
