Sensor Calibration
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 13
24 183 69 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
▼ Start screen maximum. boom length:
leave the service menu
skip calibration step / go to next menu
• Now extend main boom all the way out. Make sure you are within the allowed operating range
(especially maximum radius).
• During telescoping out the boom an additional button "OK" appears.
▼ Adjustment, maximum length:
leave the service menu
carry out max. boom length setting
skip calibration step / go to next menu
• Check whether boom is fully extended, then press "OK". Afterward next calibration step (angle)
appears.
To Next Page
Loading...
