Sensor Calibration
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 15
24 183 69 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
• Boom down.
• Release adjustment screws of the angle
sensor.
• Mechanically adjust top of angle sensor
housing exact parallel with boom by help of
inclinometer.
• Fix adjustment screws of the angle sensor.
Having adjusted the angle sensor mechanically check value and press "OK" for the next step.
▼ Calibration for "zero degree" angle:
leave the service menu
calibrate next angle
skip calibration step / go to next menu
• Now boom up to 40°, (range is 35°- 45°)
▼ Calibration for "40°" angle:
leave the service menu
calibrate next angle
skip calibration step / go to next menu
angle
sensor
To Next Page
Loading...
