To Next PageTo Next PageWhat to do if Hirschmann iVISOR mentor QVGA rigging condition isn't in crane data file?
If the selected rigging condition is not contained in the crane data file, select another rigging condition or check the programming in the crane data file.
What to do if Hirschmann iVISOR mentor QVGA Touch Panel boom is too high?
If the boom has fallen below the minimum radius or gone past the maximum angle specified in the respective load chart due to luffing up the boom too far, luff down the boom to a radius or angle specified in the load chart.
What to do if Hirschmann iVISOR mentor QVGA boom is too low?
If the boom has gone past the maximum radius or fallen below the minimum angle specified in the respective load chart due to luffing down the boom too far, luff up the boom to a radius or angle specified in the load chart.
What to do if Hirschmann Touch Panel write/read memory is defective?
If the write/read memory (RAM) or central unit is defective, replace the central unit.
What to do if Hirschmann iVISOR mentor QVGA system program file is defective?
If the system program file is defective or the Flash-EPROM is defective, upload a valid system software or replace the central unit.
General| Display Resolution | 320 x 240 pixels (QVGA) |
|---|---|
| Contrast Ratio | 300:1 |
| Power Supply | 24 VDC |
| Housing Material | Plastic |
| Display Size | 3.5 inches |
| Touch Technology | Resistive |
