44
Installation MACH 1000
Release
04
12/2015
Figure 14: Power supply unit “M” (see on page 55 “General technical data”):
AC voltage (pictured on right) or DC voltage (pictured on left)
Connecting
1 - Supply voltage
2 - Signal contact
For every supply voltage to be connected, perform the following steps:
Ensure the required conditions for connecting the supply voltage.
See “Supply voltage” on page 8.
Remove the power connector from the device.
Connect the protective conductor according to the pin assignment on the
device with the clamp.
Connect the wires according to the pin assignment on the device with the
clamps.
Mount the terminal block on the device using screws.
Connection Type “L” Type “M” VDC Type “M” VAC
, pin 1 Protective conductor Protective conductor Protective conductor
-/N, pin 2 Minus terminal of the
supply voltage
Minus terminal of the
supply voltage
Neutral conductor
+/L, pin 3 Plus terminal of the
supply voltage
Plus terminal of the
supply voltage
Line conductor
Table 8: Pin assignment of terminal block for voltage supply
To Next Page
Loading...
Need help?
General
