Hirschmann RSB20 - Configuring the MRP-Ring

Redundancy
RM Web L2B
Release 5.3 05/2012
6.1 Ring Redundancy
89
6.1.2 Configuring the MRP-Ring
To configure an MRP-Ring, you set up the network to meet your demands.
For the ring ports, select the following basic settings in the Basic
Settings:Port Configuration dialog:
Port type Bit rate Autonegotiation
(automatic
configuration)
Port setting Duplex
TX 100 Mbit/s off on 100 Mbit/s full duplex (FDX)
Optical 100 Mbit/s off on 100 Mbit/s full duplex (FDX)
Table 23: Port settings for ring ports