Hirschmann RSPE 32 - Checking the Package Contents; Installing the SD Card (Optional)

Installation RSPE 30/32/35/37
Release 12 10/2015
35
2Installation
The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
Perform the following steps to install and configure the device:
 Checking the package contents
 Installing the SD card (optional)
 Mounting a dummy panel or a media module
 Installing and grounding the device
 Installing an SFP transceiver (optional)
 Connecting the terminal blocks
 Operating the device
 Connecting data cables
 Filling out the inscription label
2.1 Checking the package contents
Proceed as follows:
 Check whether the package includes all items named in the section
“Scope of delivery” on page 62.
 Check the individual parts for transport damage.
2.2 Installing the SD card (optional)
Note: Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 63.
Proceed as follows:
 Deactivate the write protection on the SD card by pushing the write-
protect lock towards the middle of the card.
 Push the SD card into the slot with the beveled corner facing upwards.

Tighten the thumb screw hand-tight to fix the SD card.