7
Basic Operation
1
Turning the device on or o
1. Plug the power cord into a wall outlet.
2. Press the button on the remote to turn on the device. When you turn
itonfor thersttime,followthe instructions displayedonthescreenand
congurethedevice'sbasicsettings.
NOTE:
• When the device is started up, you can press the button on the remote
to turn it into standby mode; When the device is in stanby mode, you can
press the button on the remote to turn on the device.
• Plugthepowercordoawalloutletwhenyoudonotusethedevicefora
long time.
• Please waite at least 10 seconds to turn on the device again when it is shut
down.
WARNING:Insucientventilationspacewillcausethisdevicetooverheat
or become damaged.
• Do not block the air vents or place any object on this device.
• Do not place this device in any narrow, enclosed or poorly ventilated space.
• At a minimum, leave the amount of space shown in the diagram below for
this device to have proper ventilation.
20cm
5cm
20cm
Laser beam