11
Note:
1. Your phone only supports Nano-SIM cards. Do not
attempt to insert other SIM type, otherwise this may
cause phone damage.
2. Please do not remove the SIM/SD card while the card
is in use; otherwise, data loss or damage may occur.
Hisense shall not be liable to any loss, including data
loss, due to misuse of an SIM/SD card.
3. Please turn off your mobile phone before replacing or
removing its SIM/SD card.
4. SD card is not included, you need to buy separately.
Charging the battery
Charging Battery
1. Insert the large end of the USB cable into the mobile
phone charger and insert the small end into the mobile
phone USB slot, while paying attention to the direction.
2. Insert the charger into a 100~240V 50/60Hz outlet to
start charging.
3. After charging is complete, remove the USB from your
mobile phone and then unplug the charger from the
power outlet.
Charging time
1. If the AC power supply is of a lower voltage, then a
longer charging time may be needed;
2. The charging time will depend upon the current status
of the battery capacity;
3. If non-standard chargers such as computers are used
for charging, then a longer charge time may be
needed;
4. Using the mobile phone while it's charging will extend
its charging time.
Note:
1. This product is built-in battery, the purchase is already
installed battery, do not disassemble!
2. Please fully charge the battery before first using the
phone and disconnect the charger immediately after
the first charge is completed.
3. Please remove the charger from the AC power socket
To Next Page
Loading...
Need help?
General
Weight and Dimensions
