26
Hisense Mexico S. de R. L. de C. V.
Boulevard Miguel de Cervantes Saavedra No. 301, Torre
Norte, Piso 2.
Col. Ampliación Granada. C.P. 11520, Deleg. Miguel
Hidalgo. Distrito Federal
Tel. 01 (55) 55-31-35-15
BRAND: HISENSE
MODEL: Hisense F20
FCC ID: 2ADOBF20
ELECTRIC CHARACTERISTICS:
ADAPTOR
BRAND: HISENSE
MODEL: A31-501000
INPUT: 100 - 240 V ~ 50/60 Hz 0.15 A
OUTPUT: 5.0 V 1 A
RECHARGEABLE BATTERY
BRAND: HISENSE
MODEL: LP38250C
3.8 V 2500 mAh
MADE IN CHINA
Medical devices
Implanted medical devices, such as pacemakers, may be
affected by the use of this product.
Avoid potential interference radiated from the product in
the implanted medical device, by keeping the product at
least 20 cm away from the device.
Do not carry the product in the chest pocket.
Turn off the product immediately if you suspect any
interference.
ONLY FOR MEXICO
“For use in Mexico, the operation of this product is
subject to the following two conditions: (1) this equipment
or device may not cause detrimental interference and (2)
this equipment or device must accept any interference,
including interference that may cause unwanted
operation.”
27
FCC Compliance
This phone complies with section 15 of FCC Regulations
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced
radio/TV technician for help.
FCC Caution:
Any Changes or modifications not
expressly approved by the party responsible for
compliance could void the user‘s authority to
operate the equipment.
The antenna(s) used for this transmitter
must not be co-located or operating in
conjunction with any other antenna or
To Next Page
Loading...
