EasyManua.ls Logo

Hisense HSAP16FB - Clean Filter

Hisense HSAP16FB
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Turn the locking ring anticlockwise and lift the filter straight up.
2. Empty and clean the filter.
3. Refit the filter and turn the locking ring clockwise to its stop position. Check that the edges seal
properly.
Clean the filter
The filter traps larger food particles, which cannot get past the drainage pump. Empty the filter when
necessary. It should be cleaned at regular intervals depending on how often the dishwasher is used.
Clean the automatic dosing compartment
Detergent is dispensed from here
Compartment
1. The compartment can be lifted out for cleaning and relling.
2. Check that the dispensing hole is not blocked. Clean the compartment with hot water.
NOTE!
Important - ret the compartment. The dishwasher must not be used without the automatic
dosing compartment in place!
Check that the yellow
drainage pump stop on the
right in the bottom drain is in
place.
NOTE!
Dishwashing results may be affected if the filter is fitted incorrectly. The dishwasher must not be
used without the filter in place!
26
Some thick dishwasher detergent gels are not suitable for the automatic dosing compartment.
Add very thick dishwasher detergent gel into the manual detergent compartment. See the
detergent manufacturer's recommendations.
NOTE!
Normally, a small amount of dishwasher detergent will leak out when lifting out the
compartment.

Table of Contents

Related product manuals