In order to achieve good dishwashing results, the dishwasher needs soft water (water with low mineral
content). Hard water leaves a white coating on dishes and the dishwasher.
Contact the local water utility to check the water hardness in your area. This is important with regard
to how much detergent and rinse aid to use.
The first time the dishwasher is switched on, it is important that you choose the right settings to ensure
good dishwashing results. See the chapter Settings.
Set up:
• Rinse aid
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked MAX .
Press the elliptical protrusion
above the lid while pulling
upwards to open the lid
Top up with rinse aid
Drying is faster and a better result is achieved if you use rinse aid. You will also achieve a better
dishwashing result with clear and spotless dishes.
Top up the rinse aid compartment with rinse aid if you have selected Rinse aid 01 - 05.
• TAB
For water with a hardness greater than 10–12 °dH, you ought to use rinse aid with citric acid (known
as acid rinse aid).
• Automatic dosing of detergent
Checking water hardness
Before washing for the first time
Water hardness
Basic settings
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
8
To Next Page
Loading...
