Open the door. Clean the sides of the door and the door seal regularly with a slightly damp cloth.
Clean the door seal at the lower front edge of the dishwasher with a washing-up brush.
Clean the outside of the dishwasher
Door and door seal
Keep the control panel clean. If necessary, wipe it with a dry or slightly damp cloth. Never use cleaning
products – they may scratch the surface.
Control panel
The dishwasher tub is made of stainless steel and is kept clean through normal use (when used
regularly).
CLn - Run the Self-clean program
Dishwasher tub
28
Corner boost spray arm
• Press and hold the metal tube, then pull the corner boost spray arm straight up to release it.
(Before pulling up the spray arm, the metal tube must be held, otherwise it will cause deformation
of the metal tube.)
NOTE!
If the dishes are misplaced, the rotation of corner boost might be obstructed, or even blocked.
If you have hard water, limescale deposits may build up in the dishwasher. If this happens, run Self-clean
with two tablespoons of citric acid in the detergent compartment (with no dishes in the machine).
Special dishwasher cleaners are also available on the market.
If the dishwasher still contains water after the program has finished, something may be blocking the
drainage pump, which results in the Water outlet fault error message.
1.
Turn off the machine using
and remove the plug from the wall socket.
2. Remove the filter.
3. Scoop out the water from the dishwasher tub.
4. In order to inspect the drainage pump, remove the yellow drainage pump stop on the right in the
bottom drain. (Use a pair of pliers if necessary.)
5. Turn the pump wheel located behind the drainage pump stop by hand. Carefully remove any sharp
items, such as glass.
6. Refit the drainage pump stop. Refit the filter.
Remove blockages
Unblocking the drainage pump
To Next Page
Loading...
