The door and the door seal
Regularly clean the sides of the door and the door seal. Use
a slightly damp cloth (with a little cleaner if necessary).
Display panel
Keep the buttons clean and free from grease. Wipe them
clean with a dry or slightly damp cloth. Never use cleaners
– they can scratch the surface. Use the main power switch
to turn off the dishwasher before cleaning the buttons to
avoid activating any buttons unintentionally.
The dishwasher tub
The dishwasher tub is made of stainless steel and is kept
clean through normal use.
Limescale deposits
If you have hard water, limescale deposits may build up in
the dishwasher. If this happens, run a self-cleaning program
with two tablespoons of citric acid in the detergent compart-
ment (with no dishes in the machine). See Self Clean in the
chapter Using the dishwasher.
TIP!
Use citric acid or commercially available dishwasher
cleaner.
Unblocking the drain pump
If the dishwasher still contains water after the program has
finished, something may be blocking the drain pump. Such
items are easily removed.
1.
Turn off the machine using the main power switch and
unplug it from the power outlet.
2.
Remove the coarse filter and the fine filter.
3.
Scoop out the water from the dishwasher tub.
4.
In order to inspect the drain pump, remove the colored
stop on the right in the bottom drain.
5.
Turn the pump wheel located behind the drain pump
stop by hand. Carefully remove any items.
6.
Reinstall the drain pump stop along with the fine and
coarse filters.
7.
Plug the machine in again.
If the dishwasher still does not start and a whirring sound
is heard, the overflow protection has been triggered.
•
Shut off the water.
•
Unplug the unit from the power outlet.
•
Call the Customer Care Center.
NOTE!
Do not forget to reinstall the drain pump stop.
13
To Next Page
Loading...
Need help?
General
Weight and Dimensions
