Care and maintenance instructions
Top up with rinse aid
When the rinse aid needs topping up, the above symbol
lights on the display.
1.
Open the rinse aid compartment lid.
2.
Carefully top up with rinse aid to the level marked max.
3.
Wipe up any spilled rinse aid around the compartment.
4.
Close the lid firmly.
After topping up, it may take a while before the symbol goes
out.
Coarse filter
The coarse filter traps larger food particles, which cannot
get past the drain pump. Empty the coarse filter when nec-
essary.
1.
Lift the coarse filter by the handle.
2.
Empty the coarse filter. Remember to reinstall it!
Fine filter
Debris that collects on the fine filter is automatically rinsed
away during each wash. Clean the fine filter when neces-
sary.
1.
Turn the locking ring counterclockwise and lift the fine
filter straight up.
2.
Clean the fine filter.
3.
Refit the fine filter and turn the locking ring clockwise to
its stop position. Check that the edges seal properly.
Remember to refit the coarse filter!
NOTE!
Dishwashing results may be affected if the filters are in-
correctly fitted. Note that the dishwasher must not be used
without the filters in place!
NOTE!
Check that the colored stop on the
right in the bottom drain is in
place.
Spray arms
Holes and bearings can become blocked. Remove debris
using a needle or similar item. The spray arms have holes
on the bottom.
Spray arms can be removed for cleaning. Remember to fit
them firmly back into place afterward.
Lower spray arm
•
Pull the lower spray arm straight up to release it.
Upper spray arm
1.
Pull out the upper basket.
2.
Unscrew the spray arm bearings counterclockwise to
remove the spray arm from the upper basket.
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
