Hisense WFMC6010E - Water inflow fault(F01); Water level reaches overflow level(F24); Error while unlocking the door(F14); AFTER-SALES SERVICE

AFTER-SALES SERVICE
Before contacting After-Sales Service:
Try to remedy the problem yourself (see “Troubleshooting Guide”).
Restart the programme to check whether the problem has solved itself.
If the washing machine continues to function incorrectly, call After-Sales Service.
29
Action: Press “Start/Pause” button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, turn the programme
selector knob on position "OFF" for 3 seconds to turn off the machine and the alarm
will be removed.
Water level reaches overflow level.
Press the “start/pause” button to cancel the failure code and start the
programme; if the fault persists,unplug the appliance and contact
After-Sales Service(see “After-
Sales Service”).
Water level reaches overflow level(F24):(fig.9)
The appliance has none or insufficient water supply.Check whether:
The water tap is fully open and there is sufficient water supply pressure.
Kinks are present in the water hose.
The mesh filters of the water supply are blocked (see “Care And Maintenance”
or “Mesh Filters for Water Connection”).
The water hose is frozen up.
After the problem has been removed, restart the programme by pressing “Start/Pause”
again; if the fault persists, unplug the appliance and contact After-Sales Service (see
“After-Sales Service”).
Water inflow fault(F01):(fig.8)
fig.8
fig.9
Error while unlocking the door(F14).(fig.10)
fig.10