1. Power switch
Press the power switch to turn on the power.
After power-on, press the power switch to turn off the power.
If the “Start/Pause” button is not pressed in 10 minutes after the
power is turned on, the washing machine will automatically power
off .
2. Start/Pause
After power-on, press this button to start the washing machine.
While the washing machine is running, press this button to stop it.
3. Temp./Options
press Temp./Options button repeatedly to cycle through the
water temperature, air dry and tub clean
Cold>Cold, Air dry>Cold, Hot>Cold, Hot, Air dry>Hot>Hot, Air
dry>Cold, Hot, Tub Clean>Cold
Program
Choose the appropriate washing program based on the load,
texture and dirtiness of laundry.
The selection sequence is as follows: Fuzzy → Quick → Delicate
→ Jeans →Heavy→ Wool → Memory → Eco → Fuzzy
4.
5. Delay
The Delay time is within 24 hours. When the Delay is set, the
digital tube displays the reserve time, and it will be canceled when
the automatic process programming is performed again.
After the Delay is started, the ongoing process and automatic time
programming of Delay time can be stopped. During pause, the
Delay time is displayed; after the water level, soak, wash, rinse
and spin are changed, the current process, water level, function
and remaining time are showed; when the Delay time is changed,
the new Delay time is displayed; when the “Start/Pause” button is
pressed, the program controller will automatically adjust the Delay
time according to the currently required total time.
6. Selection of water level
This machine has 8 water levels for selection.
Depending on the load of laundry to be washed, press this button
to select the appropriate water level.
Water replenishing: After the program is started, press the “Water
level” button to replenish water until the button is released. And
the water level indicator does not change during this process.
The water replenishing is suitable for the soak, wash and rinse
processes. When the water reaches the highest level, the water
replenishing is automatically stopped.
In addition, no water replenishing is allowed during the fuzzy run.
Under child lock state, the manual water replenishing is
prohibited.
7. Soak
Soak or not is determined according to the dirtiness of laundry.
In quick and wool programs, the soak process cannot be started.
8.
Child lock
After the program is started, press the “Soak” and “Wash” buttons
simultaneously for 3 seconds to set or cancel the child lock. After
the child lock is started, all the buttons on the panel are invalid,
and the child lock is automatically canceled after the program
finishes.
To Next Page
Loading...
Need help?
General
