EN 6
The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block
ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space
around the entire unit.
Notes when mounting the TV on a wall
If the unit is to be mounted on the wall, contact the retailer where you purchased the TV for advice, and have the equipment professionally
installed. Incomplete or improper installation may cause injury to you, and/or damage to the TV.
The screws M4 thread type should be used. The insertion length must be within 5 -8.5 mm.
If the insertion length is less than 5 mm the weight can not be maintained.
If the insertion length is more than 8.5 mm a space is created between the Wall Mount Bracket and the Television.
(Insertion Length) = (Screw Length) - (Washers Thickness) - (Mounting Bracket Thickness)
Securing to a Wall
1 Use metallic wire, screw and clamp (not provided) on the rear of the TV as shown below.
2 Keep the TV 4 inches away from the wall, except when mounted using the wall mount bracket, and secure to the wall as shown below:
Wire
Clamp
Screw
Wire
4 inches
NOTICE FOR TV CABINET
If the unit is placed on a cabinet smaller than the length of the unit, it could result in instability and the unit may tumble over, making a risk
of personal, possibly fatal injury. Also, this would seriously damage the product. Accordingly, Hitachi accepts no responsibility or liability
for any injuries or property damage resulting from the improper installation.
NO !!YES !!
SAFETY PRECAUTIONS
To Next Page
Loading...
Need help?
General
