Hitachi airCore 700 - Field Setting; Zone Installation Setting

22
INSTALLATION & MAINTENANCE MANUAL
7. Field Setting
DO NOT Perform Test Run during system starting or before following settings are completed.
7.1 Zone Installation Setting
7.1.1 Zone Conguration Setting
If the wired controller is connected to the zone interface box, the “Zone Installation Menu” is
displayed in the “Service & Installation Menu” of Wired Remote Controller.
Service & Installation
Check Menu
Zone Installation Menu
Installation Menu
Service Menu
OK
Select Back
(Mon) 16:30
Zone Installation Menu
Sensor Assignment
Zone Labeling
Nominate Spill Zone(s)
Zone Acti8ation
Common Zone Setup
BackOK Select
(Mon) 16:30
The total airflow ratio of common zone and spill zone(s) shall not be less
than the Minimum Airflow Ratio.