13
INSTALLATION & MAINTENANCE MANUAL
5.3 Thermostat Installation
[Before Installation]
(1) This packing contains the following parts.
Item
Thermostat(GC-ZKT)
Screw Connecting Wire
Appearance
M4 × 16mm
Qty. 1 2 1
(2) When installing two thermostats one above the other,
allow a gap of at least 50mm between the two.
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the mounting plate, push
and turn the slotted screwdriver to separate and remove the thermostat from the mounting plate.
Figure Seen from Bottom Side
Slotted
Approx. 6mm
Screwdriver
NOTE:
•
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and
the thermostat cannot be installed.
Tabs for Attaching Controller
mounting plate
上
more than 50mm
To Next Page
Loading...
