Hitachi airCore 700 - Indoor Unit Configuration Setting

33
INSTALLATION & MAINTENANCE MANUAL
7.2 Indoor Unit Conguration Setting
(1) Temperature control
Please change the value of Function Selection C8 (Sensor selection for indoor
temp. control) to 01. This setting is required for the room temperatures to be
sensed from the individual thermostats or sensors.
The detailed setting steps of c8-01 are as follows:
Cancellation of Heating Temp Compensation due to Uneven Heat Load
Function Selection : 00-00
b1 b7 bd C5
b2 b8 bE C6
b3 b9 C1 C7
b5 bb C3 C9
b4 bA C2 C8
b6 bC C4 CA
01
00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
01:Standard(Set Temp. +7oF(+4oC))
Back
b-J
K-P
q-S
Confirm function selection setting?
Yes No
OK
Select Back
Function Selection
Function Selection is set from Installation Menu of the Wired Remote Controller.
Step1. Select "Installation Menu" and press "OK
" .
Step2. Select "Function Selection "and press "OK ".
Step3. Press "
OK ".
Step4. Press " " or " " to select the type tab and press "OK " .
→It changes in the order of "b-J"
↔
"K-P"
↔
"q-S"
↔
" ".
Step5. Press " ", " ", " ", or " " to select the c8 item to set from the
list area. Press "
" and press "
" or "
" to change the
Step6. To confirm the setting, press " " in the tab selection mode.
Step7. Select "Yes" and press "OK
" to confirm the setting and return
to Step2.
Select "No" and press "OK
" to discard the settings and return
to Step2.
Press "
"to return to Step5.
Installation Menu
OK
Select Back
Input/Output
Thermistor Selection
Thermistor Calibration in Controller
Function Selection
Test Run
(Mon) 16:30
Installation Menu
OK
Enter Back
Input/Output
Thermistor Selection
Thermistor Calibration in Controller
Function Selection
Test Run
OK
Select Back
OK
The function descriptions are for
reference only. Refer to technical
documents of unit for details.
OK
b1: Set heating temperature compensation
Function Selection : 00-00
b1 b7 bd C5
b2 b8 bE C6
b3 b9 C1 C7
b5 bb C3 C9
b4 bA C2 C8
b6 bC C4 CA
00
00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00
01
00 00 00 00
01:Tset+0
o
C( no compensation)
Back
OK Select
b-J
K-P
q-S
Service & Installation
Check Menu
Installation Menu
Service Menu
OK
Select Back
(Mon) 16:30
Type tab List area
setting value to 01.