Hitachi airCore 700 - Page 41

37
INSTALLATION & MAINTENANCE MANUAL
10.1.2 Zone Operation Setting
This function is to set operation (ON/OFF) of individual zone.
Step1. Press "
" or " " to select "ON/OFF".
Step2. Press "
" or " " to set zone operation.
NOTES:
•
When "Spill zone control on" displays in the bottom le corner, spill zone enters automatic control, and the
actual state of the zone may not be consistent with the set state.
•
During Setback operation, Zoning Kit does not accept zone settings.
Even if the parameters are modied, they will be restored aer one second.
10.1.3 Zone Set Temperature Setting
This function is to adjust "set temperature" of individual zone.
Step1. Press "
" or " " to select "Temp".
Step2. By pressing "
", the temperature is increased by 0.5°C or 1°C.
By pressing "
", the temperature is decreased by 0.5°C or 1°C.
NOTE:
•
The set temperature of the zone can be set to ±3°C of zone base temperature(within the range of upper and
lower limit of the set temperature).
Living
Zone 1 (Spill Zone)
BackSpill zone control on
ON
On#O%%
26 .5
C
Temp
22.5 26.2
Lo4
ON
OO
OFF
OOFF
Living
Zone 1 (Spill Zone)
BackSpill zone control on
ON
On#O%%
26 .5
C
Temp
22.5 26.2
Lo4
Zone average room
temperature
Zone base temperature
Zone set temperature