Hitachi airCore 700 - Page 46

42
INSTALLATION & MAINTENANCE MANUAL
10.2.2.2 Temperature Setting
NOTES:
•
Please refer to Wired Remote Controller Installation Manual for the setting of temperature
gradient (0.5°C or 1°C).
•
The temperature of each thermostat can be controlled to within ±3°C of the temperature that is
set on the wired remote controller (PC-ARFG2-Z) main screen.
For example, if the temperature that set on the wired remote controller
(
PC-ARFG2-Z) main
screen is 23°C, then the temperature setting range of the thermostat is:
○
the maximum temperature that can be set on each thermostat is 26°C (+3°C).
○
the minimum temperature that can be set is 20°C (-3°C).
Figure10.4
Operation step:
Press " " or " " on the thermostat to select desired temperature. Depending on the
temperature gradient selected, the temperature increases or decreases by 0.5°C or 1°C.
10.2.2.3 Setting Airow Tap
Figure10.5
Operation step:
Press" " to change airow tap as showed in Figure10.5, the airow tap changes sequentially as
shown below.
Auto
Low
Med
High