English
— 3 —
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such
as dust masks that are specially designed to fi lter out microscopic particles.
PRODUCT SPECIFICATIONS
Swing ............................................. 15” (380mm)
Chuck Size..................................... 5/8” (16mm)
No Load Speed .............................. 12 Speeds
210-2,580/min
Voltage .......................................... 220-240V / 50Hz
Watts ............................................. 750W
Amps ............................................. 3.6A
Built-in Light ................................... 60 Watt (Maximum)
(Bulb not included)
Table Size ...................................... 13-15/64” x 13-15/64”
(336mm x 336mm)
Table Tilt ........................................ 45° Right or Left
Spindle Travel ................................ 3-11/32” (85mm)
Throat ............................................ 7-1/2” (190.5mm)
Base Size....................................... 11” x 20-3/8”
(279.4mm x 518mm)
Height ............................................ 63-11/16” (1,617.5mm)
Net Weight ..................................... 165 lbs (75kg)
WARNING
To avoid electrical hazards, fi re hazards or damage to the drill press, use proper circuit protection.
This drill press is wired at the factory for 220-240 Volt operation. It must be connected to a 220-240 Volt / 3.6
Ampere time delay fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is worn,
cut or damaged in any way.
Before using your drill press, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the drill press.
000BookB16RM.indb3000BookB16RM.indb3 2015/01/1410:56:412015/01/1410:56:41
To Next Page
Loading...
