13
• If the DHCP is set on in the projector, the network connection
between the projector and computer may not be established since IP address
may be varied. If you like to use the My Connection, set the DHCP off in the
projector.
• If no profile data is assigned to the My Connection, it can’t be used.
NOTE
Proceed to item 1.8 Confirming the connection to your destination. (
31)
[Troubleshooting]
Select the [My Connection] and click the
[Connect].
If you select the My Connection, the computer
is connected to the projector through the
network by using the profile data that is pre-
assigned to My Connection. (
36)
When you select the My Connection, the
computer immediately starts the connection to
the projector.
1.4.2 Selecting My Connection
A network connection could not be established.
Windows prevented network configuration
changes.
You may log in the Windows under User
authority.
Click the [OK] to return to the screen to
select the network connection mode. (
11)
Consult to the network administrator and log in again under the Administrator
authority. After that, please resume at item 1.3.2 Starting the “LiveViewer”.
(
10)
1. Connection to the network
1.4 Selecting the network connection mode (continued)
To Next Page
Loading...
Need help?
General
