10
English
When cutting the workpiece which has the dimension of “*” there might be some possibility of the lower
end of the circular saw to touch with the workpiece, even if the motor head is located at the lower limit
position. Pay attention when cutting the workpiece. For further details, refer to “PRACTICAL APPLICATIONS”
on page 18. Mount the auxiliary board on the fence surface (Refer ( ) the thickness of auxiliary board). Refer
to "5. Cutting large workpieces" on page 20 (Fig. 27).
ACCESSORIES
WARNING: Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and could cause injury
or mechanical damage.
STANDARD ACCESSORIES
Fig. 3
OPTIONAL ACCESSORIES...sold separately
1 Extension Holder and Stopper (Code No. 321553)
2 Saw blade 10”(255mm) TCT Saw blade (Total teeth:72) (Code No. 725206)
3 Sub Fence (A) (Code No. 321387)
4 Crown molding Vise Ass’y (Code No. 321434) (Include Crown molding Stopper (L))
5 Crown molding Stopper (L) (Code No. 321374)
6 Crown molding Stopper (R) (Code No. 321373)
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.
APPLICATIONS
Wood and aluminum sash.
2 Dust bag (1 piece)1 10" (255mm) TCT Saw
blade (1 piece)
For how to use, refer to
page 25.
4 10mm BOX wrench
(1 piece)
3 Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to
page 18.
No. of teeth 40
Code No. 310878 (C329701)
01Eng_C10FSH_Eng_Spa 09/3/19, 16:4610
To Next Page
Loading...
Need help?
General
