EasyManuals Logo

Hitachi CP-A220N User Manual

Hitachi CP-A220N
261 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
4
WARNING
Be careful in handling the light source lamp.
The projector uses a high-pressure mercury glass lamp made of glass.
The lamp can break with a loud bang, or burn out. When the bulb bursts,
it is possible for shards of glass to fly into the lamp housing, and for gas
containing mercury to escape from the projector’s vent holes.
Please carefully read the section “Lamp”.
Be careful in handling the power cord and external connection
cables.
If you keep using a damaged the power cord or cables, it can cause a fire
or electrical shock. Do not apply too much heat, pressure or tension to the
power cord and cables.
If the power cord or cables is damaged (exposed or broken core wires, etc.),
contact your dealer.
Do not place the projector or heavy objects on the power cord and cables.
Also, do not place a spread, cover, etc, over them because this could result
in the inadvertent placing of heavy objects on the concealed power cord or
cables.
Do not pull the power cord and cables. When connecting and
disconnecting the power cord or cables, do it with your hand holding the plug
or connector.
Do not place the cord near the heater.
Avoid bending the power cord sharply.
Do not attempt to work on the power cord.
Be careful in handling the battery of the remote control.
Incorrect handling of the battery could result in fire or personal injury. The
battery may explode if not handled properly.
Keep the battery away from children and pets. If swallowed consult a
physician immediately for emergency treatment.
Do not allow the battery in a fire or water.
Avoid fire or high-temperature environment.
Do not hold the battery with the metallic tweezers.
Keep the battery in a dark, cool and dry play.
Do not short circuit the battery.
Do not recharge, disassemble or solder the battery.
Do not give the battery a physical impact.
Use only the battery specified in the other manual of this projector.
Make sure the plus and minus terminals are correctly aligned when loading
the battery.
If you observe a leakage of the battery, wipe out the flower and then
replace the battery. If the flower adheres your body or clothes, rinse well with
water.
Obey the local laws on disposing the battery.
Safety Precautions (continued)

Table of Contents

Other manuals for Hitachi CP-A220N

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi CP-A220N and is the answer not in the manual?

Hitachi CP-A220N Specifications

General IconGeneral
Matrix size0.63 \
Matrix type3-panel (p-Si TFT active)
Number of colors16.78 million colors
Native aspect ratio4:3
Projection distance- m
Projection technology3LCD
Contrast ratio (typical)2000:1
Digital gamma correctionYes
Screen size compatibility- \
Projector native resolutionXGA (1024x768)
Vertical synchronization (max)120 kHz
Vertical synchronization (min)50 kHz
Horizontal synchronization (max)106 kHz
Horizontal synchronization (min)15 kHz
Throw ratio0.3:1
Focal length range- mm
Lamp power210 W
Light source typeLamp
Service life of light source3000 h
Service life of light source (economic mode)5000 h
Full HDNo
Supported video modes1080i, 1080p, 480i, 480p, 576i, 720p
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 768 (WXGA), 1280 x 800 (WXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1600 x 1200 (UXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
RMS rated power10 W
Number of built-in speakers1
USB connector typeUSB Type-A, USB Type-B
Serial interface typeRS-232
USB 2.0 ports quantity2
VGA (D-Sub) ports quantity3
Component video (YPbPr/YCbCr) in0
Optical disc player typeNot included
Noise level35 dB
CertificationUL, C-UL, FCC, CE
Noise level (economic mode)28 dB
Product colorWhite
Cable lock slot typeKensington
Power sourceAC
AC input voltage90 - 264 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.3 W
Power consumption (typical)310 W
Operating temperature (T-T)5 - 35 °C
Weight and Dimensions IconWeight and Dimensions
Depth303 mm
Width344.93 mm
Height85.09 mm
Weight3900 g

Related product manuals