Hitachi CP-RX80 - Selecting an Input Signal

16
Operating
1.
Press COMPUTER button on the remote control to select
the COMPUTER IN port.
COMPUTER button
VIDEO
DOC.CAMERA
ASPECT SEARCH
BLANK
COMPUTER
MY SOURCE/
AUTO
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
MY SOURCE /
DOC. CAMERA button
1.
Press the MY SOURCE / DOC. CAMERA button on
the remote control. The input signal will be changed
into the signal you set as MY SOURCE (

44).
● This function also can use for document camera. Select
the input port that connected the document camera.
1.
Press INPUT button on the projector.
Each time you press the button, the projector switches its
input port from the current port as below.
Selecting an input signal
INPUT button
● While ON is selected for AUTO SEARCH item in OPTION
menu (

42), the projector will keep checking the ports in
above order repeatedly till an input signal is detected.
COMPUTER IN  S-VIDEO  VIDEO
1.
Press VIDEO button on the remote control.
Each time you press the button, the projector switches its
input port from the current port as below.
● While ON is selected for AUTO SEARCH item in OPTION
menu, the projector will keep checking every port sequentially
till an input signal is detected (

42). If VIDEO button is
pressed when COMPUTER IN port is selected, the projector
will check S-VIDEO port fi rst.
VIDEO button
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY B
U
TT
O
N
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
S-VIDEO

VIDEO