33
INPUT menu
Item Description
RESOLUTION
The resolution for the COMPUTER IN input signals can be set on
this projector.
(1) In the INPUT menu select the RESOLUTION using the ▲/▼
buttons and press the ► button.
The RESOLUTION menu will be
displayed.
(2) In the RESOLUTION menu select the
resolution you wish to display using
the ▲/▼ buttons.
Selecting AUTO will set a resolution
appropriate to the input signal.
(3) Pressing the ► or ENTER button when
selecting a STANDARD resolution will
automatically adjust the horizontal and
vertical positions, clock phase and
horizontal size.
The INPUT_INFORMATION dialog (
46 )
will be displayed.
(4) To set a custom resolution use the ▲/▼ buttons to select
the CUSTOM and the RESOLUTION_CUSTOM box will be
displayed.
Set the horizontal (HORZ) and
vertical (VERT) resolutions using
the ▲/▼/◄/► buttons.
This function is may not support all
resolutions.
(5) Move the cursor to OK on screen and press the ► or ENTER
button. The message “ARE YOU SURE YOU WISH TO
CHANGE RESOLUTION?” appears. To save the setting, press
the ► button.
The horizontal and vertical positions, clock phase and horizontal
size will be automatically adjusted.
After the INPUT_INFORMATION
dialog has displayed for about 10
seconds the screen will return to the
RESOLUTION menu displaying the
changed resolution.
(6) To revert back to the previous
resolution without saving changes,
move the cursor to CANCEL on
screen and press the ◄ or ENTER
button.
The screen will then return to the
RESOLUTION menu displaying the
previous resolution.
• For some pictures, this function may not work well.
STANDARD
↓
CUSTOM
↓
To Next Page
Loading...
