OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or ENTER button to
execute the item, except for the items LAMP TIME
and FILTER TIME. Then perform it according to the
following table
Item Description
AUTO SEARCH
Using the ▲/▼ buttons turns on/off the automatic signal search
function.
ON
OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN
S-VIDEO
VIDEO
DIRECT ON
Using the ▲/▼ buttons turns on/off the DIRECT ON function.
ON
OFF
When set to the ON, the lamp in projector will be automatically
turned on without the usual procedure (
14 ), only when the
projector is supplied with the power after the power was cut while
the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
•
After turning the lamp on by the DIRECT ON function, if neither
input nor operation is detected for about 30 minutes, the projector is
turned off, even though the AUTO OFF function (
To Next Page
Loading...
