40
SCREEN menu
Item Description
SOURCE NAME
Each input port for this projector can have a name applied to it.
(1) Use the ▲/▼ buttons on the SCREEN menu to select SOURCE
NAME and press the ► or ENTER button.
The SOURCE NAME menu will be displayed.
(2) Use the ▲/▼ buttons on the SOURCE
NAME menu to select the port to be
named and press the ► button. Right
side of the menu is blank until a name is
specifi ed.
The SOURCE NAME dialog will be
displayed.
(3) The current name will be displayed on
the fi rst line. Use the ▲/▼/◄/► buttons
and the ENTER or INPUT button to
select and enter characters. The RESET
button can be used to erase 1 character
at a time. Also if you move the cursor to
DELETE or ALL CLEAR on screen and
press the ENTER or INPUT button, 1
character or all characters will be erased.
The name can be a maximum of 16
characters.
(4) To change an already inserted character,
press the ▲ button to move the cursor to
the fi rst line, and use the ◄/► buttons to
move the cursor on the character to be
changed.
After pressing the ENTER or INPUT button, the character is
selected. Then, follow the same procedure as described at the
item (3) above.
(5) To fi nish entering text, move the cursor to the OK on screen
and press the ENTER or INPUT button. To revert to the previous
name without saving changes, move the cursor to the CANCEL
on screen and press the ENTER or INPUT button.
TEMPLATE
Using the ▲/▼ buttons switches the mode for the template screen.
Press the ► button to display the selected template, and press the
◄ button to close the displayed screen.
The last selected template is displayed when the
MY BUTTON
allocated to the TEMPLATE function is pressed (
To Next Page
Loading...
Need help?
General
