11
ENGLISH
Displaying the picture
1.
Activate your signal source. Turn the
signal source on, and make it send the
signal to the projector.
2.
Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from
the VIDEO port, or the COMPUTER
button for selecting an input signal from
the COMPUTER IN port.
3.
Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
4.
Use the ZOOM ring to adjust the screen
size.
5.
Use the FOCUS ring to focus the picture.
INPUT button
VIDEO button
COMPUTER button
ASPECT button
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT
SEARCH
BLANK
MUTE
MY BUTTON
POSITION
ESC
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
DOWN
ON
OFF
FREEZE
UP
㧗
VOLUME
ENTER
CAUTION ►If you wish to have a blank screen while the projector's lamp is
on, use the BLANK function. (see User’s Manual - Operating Guide)
Taking any other action may cause the damage on the projector.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• For the details of how to adjust the picture, please see User’s Manual -
Operating Guide.
ZOOM ring
FOCUS ring
To Next Page
Loading...
