26
3.1.6 Alert Settings
Displays and configures failure & alert settings.
Item Description
Cover Error The lamp cover has not been properly fixed.
Fan Error The cooling fan is not operating.
Lamp Error
The lamp does not light, and there is a possibility that interior
portion has become heated.
Temp Error
There is a possibility that the interior portion has become heated.
Air Flow Error The internal temperature is rising.
Cold Error
There is a possibility that the interior portion has become
overcooled.
Filter Error Filter time over.
Other Error
Other error.
If displaying this error, please contact your dealer.
Schedule Execution
Error
Failed to execute schedule events.
Lamp Time Alarm Lamp Time has exceeded the specified alarm limit.
Filter Time Alarm Filter Time has exceeded the specified alarm limit.
Filter Status Notification
The status to clean the air filter is changed.
Transition Detector
Alarm
Transition Detector Alarm. (
SECURITY menu in the
Operating Guide)
Cold Start
When the projector is supplied with the power, it works as
below.
•
If the STANDBY MODE is set to the NORMAL:the projector's
power status changes from “OFF” to “Standby state”.
•
If the STANDBY MODE is set to the SAVING:the projector's power
status changes from “Standby state” to “ON (lamp is turned on)”.
(
SETUP menu in the Operating Guide)
Authentication Failure
The SNMP access is detected from the invalid SNMP community.
Refer to
Troubleshooting in the Operating Guide for further detailed
explanation of Error except Other Error and Schedule Execution Error.
3. Web Control
3.1 Projector Web Control (continued)
To Next Page
Loading...
Need help?
General