Hitachi CP-WX3011N - Command Control Via the Network

84
7.4 Command Control via the Network
<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&
commands.
Communication Port
The following two ports are assigned for the command control.
Command Control Settings (
50
)
&OLFNWKH[Enable] check box to open Network Control Port1 (Port: 23) to use
7&3&OLFNWKH[Enable] check box for the [Authentication] setting when
DXWKHQWLFDWLRQLVUHTXLUHGRWKHUZLVHFOHDUWKHFKHFNER[
&OLFNWKH[Enable] check box to open Network Control Port2 (Port: 9715) to
XVH7&3&OLFNWKH[Enable] check box for the [Authentication] setting
ZKHQDXWKHQWLFDWLRQLVUHTXLUHGRWKHUZLVHFOHDUWKHFKHFNER[
&OLFNWKH[Apply] button to save the settings.
&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG
Example,IWKH,3DGGUHVVRIWKHSURMHFWRULVVHWWR192.168.1.10:
1) Enter “http://192.168.1.10/” into the address bar of the web browser.
2) Enter your user name and password, and then click the [OK].
&OLFNWKH[Port Settings] on the main menu.
7. Other Functions
7&3(Network Control Port1 (Port: 23))
7&3(Network Control Port2 (Port: 9715))
&RPPDQGFRQWUROLVDYDLODEOHRQO\YLDWKHVSHFL¿HGSRUWDERYH NOTE