Hitachi CP-WX3011N - Turning off the Power

12
Turning off the power
1.
Press the STANDBY/ON button on the
projector or the remote control.
7KHPHVVDJH³3RZHURII"´ZLOODSSHDURQ
the screen for about 5 seconds.
2.
Press the STANDBY/ON button again
while the message appears.
The projector lamp will go off, and the
POWER indicator will begin blinking in
orange. Then the POWER indicator will
stop blinking and light in steady orange
when the lamp cooling is complete.
3.
Attach the lens cover, after the POWER
indicator turns in steady orange.
Do not turn the projector on for about 10 minutes or more after turning it off.
Also, do not turn the projector off shortly after turning it on. Such operations might
cause the lamp to malfunction or shorten the lifetime of some parts including the lamp.
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
POSITION
12
ESC
ENTER
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
WARNING Ź'RQRWWRXFKDURXQGWKHODPSFRYHUDQGWKHH[KDXVWYHQWV
during use or just after use, since it is too hot.
Ź5HPRYHWKHSRZHUFRUGIRUFRPSOHWHVHSDUDWLRQ7KHSRZHURXWOHWVKRXOGEH
close to the projector and easily accessible.
NOTEPlease power off the projector after any connected devices are
powered off.
7KLVSURMHFWRUKDVWKH$8722))IXQFWLRQWKDWFDQPDNHWKHSURMHFWRUWXUQRII
DXWRPDWLFDOO\)RUPRUHLQIRUPDWLRQSOHDVHVHH³2SHUDWLQJ*XLGH´
(

17, 19)
STANDBY/ON button
POWER indicator