Hitachi CP-WX3011N - Page 197

88
Automatic Connection Break
7KH7&3FRQQHFWLRQZLOOEHDXWRPDWLFDOO\GLVFRQQHFWHGDIWHUWKHUHLVQR
communication for 30 seconds after being established.
The projector does not accept commands without authentication success
when authentication is enabled. The projector uses a challenge response type
DXWKHQWLFDWLRQZLWKDQ0'0HVVDJH'LJHVWDOJRULWKP
:KHQWKHSURMHFWRULVXVLQJD/$1DUDQGRPE\WHVZLOOEHUHWXUQHGLI
DXWKHQWLFDWLRQLVHQDEOHG%LQGWKLVUHFHLYHGE\WHVDQGWKH$XWKHQWLFDWLRQ
3DVVZRUGDQGGLJHVWWKLVGDWDZLWKWKH0'DOJRULWKPDQGDGGWKLVLQIURQWRIWKH
commands to send.
)ROORZLQJLVDVDPSOHLIWKH$XWKHQWLFDWLRQ3DVVZRUGLVVHWWR³SDVVZRUG´DQGWKH
UDQGRPE\WHVDUH³DIF´
Authentication
6HOHFWWKHSURMHFWRU
5HFHLYHWKHUDQGRPE\WHV³DIF´IURPWKHSURMHFWRU
%LQGWKHUDQGRPE\WHV³DIF´DQGWKH$XWKHQWLFDWLRQ3DVVZRUG
³SDVVZRUG´DQGLWEHFRPHV³DIFSDVVZRUG´
'LJHVWWKLVELQG³DIFSDVVZRUG´ZLWK0'DOJRULWKP
,WZLOOEH³HGDGIIDEFHIGEGH´
$GGWKLV³HGDGIIDEFHIGEGH´LQIURQWRIWKHFRPPDQGV
and send the data.
6HQG³HGDGIIDEFHIGEGH´FRPPDQG
6) When the sending data is correct, the command will be performed and the
reply data will be returned. Otherwise, an authentication error will be returned.
$VIRUWKHWUDQVPLVVLRQRIWKHVHFRQGRUVXEVHTXHQWFRPPDQGVWKH
authentication data can be omitted when the same connection.
NOTE
7. Other Functions
7.4 Command Control via the Network (Continued)