44
CP-X2511N(C15I-25N2) / CP-X3011N(C15I-30N2) / CP-X4011N(C15I-40N2) / CP-X2011N(C15-20N2) / ED-X45N(C15-20N2)
Wiring diagram 6
Wiring around lamp house
(1) Attach and wire CNTS and CNLAP
(2) Attach FE10
Secure the CNTS (cable of TSW) with a screw.
Secure the CNLAP with a screw.
CNTS
CNLAP
Screw
Place the ferrite core FE10 on
the boss of the bottom case.
Check the ferrite core FE10 has
been attached here. If not,
attach the ferrite core to the
CNLAP with the projection
upwards. Make sure not to
attach it to the CNTS.
The boss of the upper case
will come to this area.
Pass the CNTS behind the CNLAP, and style them so
that they do not protrude from the bottom case.
Wire the CNTS and the CNLAP so that they do not
protrude from the dotted line drawn on the picture to
the right side, since the boss will come to the area
shown on the picture when you attach the upper case.
If you put two wires side by side, they might
be pinched and damaged. Therefore, put a
wire upon another as shown in the diagram.
Cross sectio
n
NG GOOD
Rib
Boss
The wires might
be damaged.
Push the CNLAP and the
CNTS behind the ribs.
Otherwise, the cables will be
pinched between the upper
case and the bottom case.
To Next Page
Loading...
