43
CP-X2511N(C15I-25N2) / CP-X3011N(C15I-30N2) / CP-X4011N(C15I-40N2) / CP-X2011N(C15-20N2) / ED-X45N(C15-20N2)
Wiring diagram 5
Wiring around panel duct 2
(1) Wire and secure CNFL2 and CNBAT
(2) Wire and secure #3010, #3020, CNRC and E1
CNBAT
CNFL2
Attach the #3000 cable to the
duct with a tape ZTP6.
SENSOR
board
Attach the CNFL2 and CNBAT cables
to the duct with a tape ZTP4.
Do not stick the tape ZTP4 on the
ventilating holes of the panel duct and
the edges of the ventilating holes, or
the bosses with the screw hole
Do not let the wires
loosened.
Do not pass the wires
over the boss.
Secure the cables to the claws
Do not let the #3010
cable loosened.
CNTS
Do not let the #3020 and E1 cable loosened.
Let the CNRC loosened a little.
Secure the CNRC to the
slits on the left side.
Secure the #3020 and
the E1 to the slits on the
right side.
Ventilating holes
of Panel Duct
BATTERY
board
Do not let the wires loosened.
Do not pass the wires over the
boss.
To Next Page
Loading...
