29
5.1 Preparing menu operation
If you use Simple Stack without RS-232C cable connection, select the input port
that you connect the cables to, pressing COMPUTER or VIDEO button on the
remote control or INPUT button on the control panel on both projectors. For
setting of the MONITOR OUT, refer to SETUP menu in the Operating Guide.
Then, the setting is nished.
If you use Intellectual Stack with RS-232C cable connection, the setting or
changing anything related to menu operation for Intellectual Stack requires to be
done on Main projector. So Main projector should be working for input source
setting on Intellectual Stack.
5.2 Checking Main projector’s operating status
On Intellectual Stack, setting or changing related to menu operation requires to
be done on Main projector. Before starting menu operation for Intellectual Stack,
check whether or not Main projector is working as below.
1.
Press MENU button on the remote control.
2.
If MENU dialog as right appears on screen, it is
conrmed that the two projectors are working in DUAL
mode and Main projector is surely working.
Go to 5.4 Setting on menu. (
31
)
If the dialog does not appear, LAMP MODE is set to ALTERNATE and either
Main or Sub projector is working. Go to next.
3.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
(
Operating Guide → OPTION menu).
4.
Check STACK MODE setting in STACK menu.
- If MAIN is shown, it is conrmed that Main projector is working. Go to 5.4
Setting on menu. (
31
)
- If SUB is shown, it is conrmed that Main projector is turned off and Sub is
working. Go to 5.3 Starting Main projector. (
30
)
5. Setting for input port on menu
To Next Page
Loading...
