32
Setting for input port on menu
Inputting image to Sub from Main
- Video signal (either COMPONENT or VIDEO)
1.
If STACK menu is already on screen, proceed to 3 below. Otherwise press
MENU button on the remote control.
If MENU dialog is displayed, use the ▲/▼ buttons to point at MAIN, and press
the ► button. Then, a menu appears on screen.
If not, a menu directly appears on screen.
2.
Press MENU button on the remote control or
control panel on Main projector. Then, using
the ▲/▼/◄/► buttons, open COMPUTER IN
dialog. (
Operating Guide → INPUT menu)
3.
If you input component signal on either COMPUTER IN 1 or IN 2 port, set
AUTO at the port. Then, use the ▲/▼/◄/► buttons to point at EXIT and
press the ► button to complete the setting.
If you input video signal on either COMPUTER IN 1 or IN 2 port, set VIDEO
at the port. If it is necessary to select a video format, use the ▲/▼/◄/►
buttons to point at RETUEN and press the ◄ button to display INPUT menu,
otherwise use the ▲/▼/◄/► buttons to point at EXIT and press the ► button
to complete the setting.
4.
Select VIDEO FORMAT in INPUT menu to
display VIDEO FORMAT dialog.
Select AUTO or appropriate format for the
port that you input video signal.
Then, use the ▲/▼/◄/► buttons to point at EXIT and press the ► button to
complete the setting.
Inputting image of Sub and Main individually
1.
If STACK menu is already on screen, proceed to 3 below. Otherwise press
MENU button on the remote control.
If MENU dialog is displayed, use the ▲/▼ buttons to point at MAIN, and press
the ► button. Then, a menu appears on screen.
If not, a menu directly appears on screen.
2.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
(
Operating Guide → OPTION menu)
(continued on next page)
To Next Page
Loading...
