Hitachi CP-X417 - Freezing the Screen; Temporarily Blanking the Screen

To Next Page

To Previous Page

Operating

Press BLANK button on the remote control.

The BLANK screen will be displayed instead of the screen of

input signal. Please refer to BLANK item in SCREEN menu

(38).

To exit from the BLANK screen and return to the input signal

screen, press BLANK button again.

Temporarily blanking the screen

● The projector automatically returns to the input signal screen

when one of the projector’s buttons or the remote control

buttons (except ASPECT, POSITION, MAGNIFY or FREEZE

button, also except MY BUTTON1/2 if AUTO KEYSTONE

or MY MEMORY or PICTURE MODE is assigned to (44)) is

pressed.

•

The sound is not connected with the BLANK screen function.

If necessary, set the volume or mute rst.

NOTE

Press the FREEZE button on the remote control.

The “FREEZE” indication will appear on the screen (however,

the indication will not appear when the TURN OFF is selected

for the MESSAGE item in the SCREEN menu (41)), and

the projector will go into the FREEZE mode, which the picture

is frozen.

To exit the FREEZE mode and restore the screen to normal,

press the FREEZE button again.

Freezing the screen

● The projector automatically exits from the FREEZE mode when one of the

projector’s buttons or remote control buttons of STANDBY/ON, SEARCH,

COMPUTER, VIDEO, BLANK, AUTO, VOLUME, MUTE, KEYSTONE, MENU,

MAGNIFY and MY BUTTON1/2 (except MY MEMORY or PICTURE MODE is

assigned to) (44) is pressed.

● If the projector continues projecting a still image for a long time, the LCD

panel might possibly be burned in. Do not leave the projector in the FREEZE

mode for too long.

FREEZE button

HOME

PAGE UP

PAGE DOWN

END

VIDEO

FREEZE

OFF

MAGNIFY

ASPECT AUTO

BLANK

MUTE

VOLUME

KEYSTONE

MY BUTTON

POSITION

1 2

ESC

ENTER

RESET

COMPUTER

BLANK button