Hitachi CP-X417 - Cleaning and Replacing the Air Filter

66
Maintenance
Please check and clean the air lter periodically. When the indicators or a
message prompts you to clean the air lter, comply with it as soon as possible.
Replace the air lter when it is damaged or too soiled. To prepare a new air lter,
contact to your dealer and tell the air lter type number.
Cleaning and replacing the air lter
Type number : MU04951
1.
Turn the projector off, and unplug the power cord.
Allow the projector to sufciently cool down.
2.
Use a vacuum cleaner on and around the lter cover.
3.
Pull the lter cover knobs while lifting it. The lter unit
which consists of the lter’ cover, air lter and lter
frame will come off.
4.
Use a vacuum cleaner for the lter vent of the
projector and the lter frame side of the lter unit.
If the air lter is damaged or too soiled, replace it
according to the following procedure number 5 to 7.
Otherwise, please jump to the procedure number 8.
5.
Pull the lter frame’s knob up while holding the lter
cover. The lter frame will come off and the air lter
will appear.
6.
Replace the air lter with new one.
7.
Put the lter frame back.
8.
Put the lter unit back into the projector.
When you replace the lamp, please replace the air lter. An air lter of specied
type will come together with a replacement lamp for this projector.
Filter cover
Filter cover knobs
Filter unit
Filter cover
Filter frame
Air lter
(continued on next page)