24
Operating
Using the menu function (continued)
● Some functions cannot be performed when a certain input port is selected, or
when a certain input signal is displayed.
●
When you want to reset the operation, press RESET button on the remote
control during the operation. Note that some items (ex. LANGUAGE, H
PHASE, VOLUME) cannot be reset.
● In the Advanced Menu, when you want to return to the previous display, press
the ◄ cursor button or ESC button on the remote control.
5.
Press MENU button on the remote control again to close the menu and
complete this operation. Even if you do not do anything, the dialog will
automatically disappear after about 10 seconds.
2.
Use the ▲/▼ cursor buttons to select a menu.
If you want to change it to the EASY MENU, select
EASY MENU.
Then press the ► cursor button, or ENTER button to
select an item. The lower layer menu of the selected
item will appear.
In the Advanced Menu
3.
Use the ▲/▼ cursor buttons to select an item to operate.
Then press the ► cursor button, or ENTER button to progress. The operation
menu of the selected item will appear.
4.
Use the ▲/▼ cursor buttons to operate the item.
Advanced Menu
To Next Page
Loading...
Need help?
General
