Using the automatic adjustment feature
Press the AUTO button on the remote control.
The vertical position, the horizontal position, the clock phase
and the horizontal size will be automatically adjusted.
And the aspect ratio will be automatically selected. Make sure that the
application window is set to its maximum size prior to attempting to use this
feature. A dark picture may still be incorrectly adjusted. Use a bright picture
For a video signal or s-video signal
best suited for the respective input signal and the aspect
ratio will be selected automatically.
This function is available only when the AUTO mode is selected to the
VIDEO FORMAT item in the INPUT menu
signal, the signal type is identifi ed automatically independently of this
For a video signal, s-video signal or component video signal
The vertical position and horizontal position will be automatically adjusted.
For a component video signal
The aspect ratio will be automatically selected.
The clock phase will be automatically adjusted.
● The automatic adjustment operation requires approximately 10 seconds. Also
please note that it may not function correctly with some input.
Press the POSITION button on the remote control.
The “POSITION” indication will appear on the screen.
Use the cursor buttons ▲/▼/◄/► to adjust the picture
When you want to reset the operation, press the RESET button on the remote
control during the operation.
To complete this operation, press the POSITION button again. Even if you don’t
do anything, the dialog will automatically disappear after a few seconds.
● When this function is performed at a video signal, a certain extra such as a line
may appear outside a picture.
VIDEO
RG
B
SEARC
H
FREEZE
OFF
ON
MAGNIFY
ASPECT AUTO
BLAN
K
MUTE
VOLUME
KEYSTONE
POSITION
ES
C
ENTE
R
MENU
RESE
T
VIDEO
RG
B
SEARC
H
FREEZE
OFF
ON
MAGNIFY
ASPECT AUTO
BLAN
K
MUTE
VOLUME
KEYSTONE
POSITION
ES
C
ENTE
R
MENU
RESE
T
To Next Page
Loading...
