Adjusting the projector's elevator
Do not adjust the projector’s elevator during use or
immediately after use. Handling while the projector is in a high temperature
could cause a burn and/or malfunction to the projector.
►If you press the elevator button without holding the projector,
the projector might crash down, overturn, smash your fi ngers and possibly
To prevent damaging the projector and injuring yourself,
always hold the projector whenever using the elevator buttons to adjust the
Do not incline the projector rightward or leftward. Also do not incline it
backward or forward exceeding 9 degrees. Exceeding these range could cause
malfunction, and could shorten the lifetime of the consumables.
►Except for inclining by the elevator feet adjustment, place the projector
You can use the elevator feet to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator feet is 0 to 9 degrees.
After making sure that the projector is cool adequately, press and hold in the
elevator buttons while holding the projector.
The elevator buttons and the elevator feet are on the both sides.
Raise or lower the projector to the desired height and release the elevator
When you release the elevator buttons, the elevator feet will lock into position.
If necessary, you can also fi nely adjust the height of the projector by twisting
the elevator feet by hand.
To Next Page
Loading...
