Using the buttons ▲/▼ switches
mode for the start-up screen
The start-up screen is a screen displayed when no signal or an
unsuitable signal is detected.
MyScreen is a screen you can register as a desired screen.The
ORIGINAL screen is the existing standard screen. When TURN
OFF is selected, the BLACK screen is used.
To avoid remaining as an afterimage, the MyScreen and the
ORIGINAL screens will change to the BLANK screen after several
minutes. If also the BLANK screen is the MyScreen or ORIGINAL, it
will change to the BLACK screen.
For the MyScreen, please refer to the item MyScreen
please refer to the BLANK
This item functions for capturing the MyScreen of the blank screen
and the start-up screen. Please execute displaying the input
including the picture you want to capture.
1. Selecting this item displays a dialog titled “MyScreen”. It will ask
you if you start capturing the picture from the current screen.
Please wait for the target picture to be displayed, and press
the ENTER button on the remote control when the picture is
displayed. The picture will freeze and the frame for capturing
To stop performing, press the RESET or ESC button on the
2. Using the buttons ◄/►/▲/▼ adjusts the frame position. Please
move the frame to the position of the picture which you want to
To start registration, press the ENTER button on the remote
To restore the screen and return to the previous dialog, press the
RESET or ESC button on the remote control.
minutes. When the registration is
completed, the registered screen and the message “MyScreen
registration is fi nished.” are displayed for several seconds. If the
registration failed, the message “A capturing error has occurred.
Please try again.” is displayed.
turns on/off the MyScreen lock function
When the TURN ON is selected, the item MyScreen is locked. Use
this function for protecting the current MyScreen.
To Next Page
Loading...
