Hitachi CP-X440 - Page 29

29
Multifunctional settings
Item
Description
H SIZE
Using the buttons ▲/▼ adjusts the horizontal size.
Large

Small
•
This item can be selected only for an RGB signal
.
•
When this adjustment is excessive, the picture may not be
displayed correctly. In such a case, please reset the adjustment
by pressing the RESET button on the remote control during this
operation.
AUTO ADJUST
EXECUTE
Selecting this item performs the automatic adjustment feature.
For an
RGB signal
The vertical position, the horizontal position, the clock phase and
the horizontal size will be automatically adjusted. And the aspect
ratio will be automatically selected.
Make sure that the application window is set to its maximum size
prior to attempting to use this feature. A dark picture may still be
incorrectly adjusted. Use a bright picture when adjusting.
For
a
For a For
video signal or s-video signal
The video format best suited for the respective input signal will be
selected automatically.
This function is available only when the AUTO mode is selected to
the VIDEO FORMAT item in the INPUT menu. For a component
video signal, the signal type is identifi ed automatically independently
of this function.
For a video signal, s-video signal or component video signal
The vertical position and horizontal position will be automatically
adjusted.
For a component video signal
The aspect ratio will be automatically selected.
The clock phase will be automatically adjusted.
•
The automatic adjustment operation requires approximately 10
seconds. Also please note that it may not function correctly with
some input.
IMAGE Menu (continued)