–
26
–
EN
You can check information about the current disc by pressing
DISPLAY on the remote control.
Press DISPLAY during play-
back to show current Chapter.
• The elapsed and remaining
time of the current chapter will be displayed.
Press DISPLAY again to show current title.
• The elapsed and remaining time of the current title will
be displayed.
Press DISPLAY again.
• The BIT RATE and the current repeat setting will be
displayed.
• If you are playing a dual layered disc, the layer number
will also be displayed ( L0: Layer 0 is playing. L1: Layer
1 is playing).
Press DISPLAY again to remove the display.
Press
DISPLAY during playback, the current track will be
displayed on the TV screen.
• The elapsed and remaining time of the current track will
be displayed.
Press DISPLAY again to show the total time of the disc.
• The elapsed and remaining time of the disc will be dis-
played.
Press DISPLAY again to remove the display.
3
2
1
CD
4
3
2
1
DVD
Changing the On-Screen Display
Some DVD discs contain scenes which have been shot
simultaneously from various angles. You can change the
camera angle when the ( ) mark appears on the screen. If
the “ANGLE MARK” setting is “OFF” in the Display setting,
the ( ) icon will not appear. (Refer to page 28.)
Press
ANGLE during playback.
• The selected angle will be displayed on the display bar
at the top of the screen.
Press
ANGLE repeatedly to select your desired angle.
2
1
DVD
Camera Angle
PLAYING A DISC
The DVD/VCR allows you to select a specific language
during DVD disc playback when multiple languages are avail-
able.
Press
AUDIO during playback.
Press
AUDIO repeatedly to select your desired language.
NOTES:
• If your language is not shown after pressing AUDIO sev-
eral times, the disc may not have that language.
However, some discs allow you to change audio lan-
guage or subtitle language setting in the disc menu.
(Operation varies depending on the disc, so refer to the
manual included in the disc.)
• If you choose a language that has a 3 letter language
code, the code will be displayed every time you change
the Audio language setting. If you choose any other lan-
guages, “---” will be displayed instead. (Refer to page
29.)
2
1
DVD
Audio Language
Subtitle Language
Press AUDIO repeatedly during playback to select
among “STEREO”, “L-CH” or “R-CH”.
STEREO- both right and left channels are active
L-CH - only left channel is active
R-CH - only right channel is active
NOTE:
• If the Virtual Surround setting is “1” or “2”, the sound
mode will be fixed to “STEREO”, and can not be
changed.
1
CD
Stereo Sound Mode
The DVD/VCR allows you to select a language for subtitle
(if available) during DVD disc playback.
Press SUBTITLE during playback.
Press
SUBTITLE repeatedly to select your desired subti-
tle language.
• The selected language will be displayed on the display
bar at the top of the screen.
To turn off subtitles, press
s or B until “OFF” appears.
NOTES:
• If your language is not shown after pressing SUBTITLE
several times, the disc may not have that language.
However, some discs allow you to change subtitle lan-
guage setting in the disc menu. (Operation varies
depending on the disc, so refer to the manual included in
the disc.)
• If you choose a language that has a 3 letter language
code, the code will be displayed every time you change
the Subtitle language setting. If you choose any other
languages, “---” will be displayed instead. (Refer to page
29.)
3
2
1
DVD
To Next Page
Loading...
